Fan Drive Pulley Assembly – 3.125″ Fan Bolt Pattern
International / Farmall Tractor: Cub, Cub Lo-Boy (C60 Engine, Engine Serial 165153 and up), Super A, Super A-1 (C113 Engine, Engine Serial 317192 and up), Super AV, Super AV-1, Super C, 100, 130, 200, 230, 240
For applicable models with 3.125″ center-to-center fan mounting bolts. Super A, Super A-1, Super AV, Super AV-1, and Super C must be equipped with a water pump. For 200, 230, and 240 models, verify applications with C123 Engine, Engine Serial 65000 and below.
International / Farmall Tractor: 140 (Replacement application only; not the original fan drive pulley assembly type. Has been installed and used on many 140 models. Verify measurements before ordering.)
Fan Bolt Spacing: 3.125″ center to center - Rear Pulley Outside Diameter: 4.379″ - Front Pulley Outside Diameter: 4.062″ - Fan Mounting Screw Threads: #12-24 UNC - Shaft Threads: 5/8″-18 NF
Requires a 5/8″-18 NF nut. A properly sized flat washer may be required on the shaft as a spacer before installing the fan assembly.
131486C91, 357004R91
Verify pulley measurements and fan mounting bolt pattern before ordering. Some applications require a 3.500″ center-to-center bolt pattern.
For early Cub models, see SKU 251427R91.
For early Super A and Super C models, see SKU 131489C91.